Centre of Gravity · Cambridge syllabus 1.5.3 · Lesson 1 of 2
Centre of Gravity
The centre of gravity is the point through which the resultant weight acts. Suspend a flat shape from a point and draw a vertical plumb line. Repeat from another point; the lines intersect at its centre of gravity.
By the end, you can
- Understand the point through which the weight of an object acts.
- Locate the centre of gravity experimentally.
Centre of gravity
The weight of an object is really spread through all of it, but for any calculation it can be treated as acting at a single point: the centre of gravity. For a uniform, symmetrical object it sits at the geometric centre — the middle of a ruler, the intersection of the diagonals of a rectangular card.
It does not have to lie inside the material. The centre of gravity of a ring, or of a horseshoe, is in the empty space it encloses, which is a useful reminder that it is a calculated point rather than a physical part of the object.
To find it experimentally for a flat, irregular shape, hang the shape from a hole near its edge and let it settle. It comes to rest with its centre of gravity directly below the point of support, so a plumb line hung from the same point marks a line the centre of gravity must lie on. One line is not enough — it only narrows the answer to that line — so repeat from a second, well-separated hole and draw a second line. The centre of gravity is where they cross. A third suspension is a worthwhile check: all three lines should meet at one point.
Worth remembering
- Centre of gravity = the single point through which the whole weight can be taken to act.
- A suspended object hangs with its centre of gravity directly below the pivot.
- Two plumb lines from different points locate it; a third checks it.
Worked example
A uniform rectangular card has its centre of gravity at the intersection of its diagonals.
When does it topple?
Change a value and watch the readings follow. Open it on the lab stage
When does it topple?
Let go here, it falls back: the weight line is 0.128 m inside the base.
- Tilt needed to topple
- 26.565°
- tan⁻¹(0.5 m ÷ 1 m)
- Weight line inside the base
- 0.128 m
Goal
Find what decides whether a tilted block falls back or topples over, and how to make it harder to topple.
Predict, where you are
If Ithe, thewill
Say what you expect before you move anything. Check makes the change for you.
Test, still to come
Change one thing at a time and watch the readings. The notebook keeps a reading each time you record one.
Explain, still to come
After you check a prediction, this says why it happened.
Try this · 0 of 3
- Tilt the block until its weight line leaves the base., not yet
- Make the block need more than 45° of tilt before it topples., not yet
- Keep the base at 1 m and lower the centre of gravity. How much further can it tilt now?, not yet
weight line outside the base → the weight turns the block over
tilted 20°; it topples beyond 26.565° with a 1 m base and its centre of gravity 1 m up
Investigation notebook · 0 readings
Change one variable at a time and record the results. These readings stay here until you leave this lesson or reset the notebook.
About this model
A rigid, uniform rectangular block, its centre of gravity half-way up, tipped about the lower edge it leans towards. The drawing holds it at the tilt set; it is not animated.
Practice
Warm-up · not marked
Check your understanding
Answer in your own words, then compare with the worked answer. Nothing here is saved or scored.
Worked answer
One gives a line of possible locations. A second line locates their intersection.
Check your method, units and explanation against it.
Marked practice
Set 1 of 4 · easiest first · Checked as you go, with the worked answer. Sign in or create a free account to save your progress.